How To Clean A Whirlpool Washing Machine Pump

Remove litter from it collect the pump and put it in place.

How to clean a whirlpool washing machine pump. Flourished with case-lets drawn from contemporary businesses it. By cleaning the filter you protect your washer from breaking down. If playback doesnt begin shortly try restarting your device.

Appliance Repair School 1987-1988. No build up anywhere Im pretty sure. The location of the drain pump filter in a Whirlpool Duet washer is accessible through the lower access panel below the washer door.

Regular maintenance helps to prevent dirt from clogging the machine and also bacteria from creating a strong mildewy smell inside the washer. How to Clean the Pump on a Whirlpool Washing Machine Step 1. Lift the front end and place two-by-four blocks under each foot to keep the front elevated.

Unplug your Whirlpool Duet washer power cord from the wall outlet. To do this with the washer unplugged lay the washer flat then you will see the pump towards the righttake it out and then clean it completely also there is a waste pipe from the drum to the pumptake that out and clean that as well completelyonce you have cleaned it the error should be resolvedlet. Set the machine to its original position connect it to all communications and start washing so that later you can see how the water drains.

Before opening the filter compartment and pulling it out put a washcloth under the opening to ensure no water leaks out. Turn off the water supply to the machineunplug from the mains supplyLay machine flat on its faceon an old pillow or similar to stop any damage to the front of the machineUnscrew and remove the tin backing plateAt the bottom of the drum on the right hand side is the pump unitThere is a rubber waste pipe from the drum to the pump held at either end with a sprung wire clipCompress the clip with a set of water. Unscrew the three screws at the bottom of the panel using a Phillips screwdriver.

Other washers are similar. Of course your model may be different so you may need to consult the users manual or. Your first step is to find the filters location.