How To Plumb In A Washing Machine Waste Pipe Uk

Fitting the waste pipe too far away from the dish washer.

How to plumb in a washing machine waste pipe uk. Place your dishwasher on a firm level floor close to an outside wall if possible. We do not advise this method as it can take up a great deal of room in your under sink cupboards and the hoses usually need to be extra long which means they have a tenancy to sag and allow stale water to sit in them. Installing waste pipes for washing machines and dishwashers can be done fairly simply by using long hoses and connecting them into the waste trap of your sink.

UK Modern Slavery Statement. Remove the transit bolts and replace them with the blanks provided. To connect the waste pipe simply slide it onto the connector see fig 18.

My washing machine waste is currently connected to the sink waste trap via an extended pipe which seems a bit daft as the main waste pipe runs behind the wmachine can I put the sink on a normal P trap add a U bend or P trap T connection halfway along the run behind the wmachine with a short length of pipe coming out of the top of the T connection to form a stand pipe. Washing machine waste pipe - into toilet waste pipe. All waste connections and pipes must be one and a half inches in diameter 40mm.

Plumbing into the u-bend is considerably easier and cheaper. Each rubber hose will have a washing machine valve at the end of it which has a red or blue lever. Installing waste pipes for washing machines and dishwashers can be done quite simply but extra-long hoses tend to sag and let stale waster stand in them.

The thing is that theres only one waste pipe and thats already used by the washing machine. Before you start check your washing machine or dishwasher is compatible with these fittings. Look at the large 4 inch stack pipe on the outside of your home where the toilet is connected see photo below.

This will either be loose in a standpipe connected to the house waste pipe or pushed onto a spigot near the sink trap it may have a screw clip holding it in place. While holding the overflow kitchen sink waste pipe thread the screw through from the sink side to grip it. I wasnt to plumb the washing machine waste into my sink.