How To Drain A Whirlpool Washing Machine Manually

On a front-load washer remove the rear access panel.

How to drain a whirlpool washing machine manually. This may drain any excess water that could cause the machine to remain locked. If it is hard-wired into your electrical system switch off the. It is also possible that there is a special lever to open the door.

Make sure that your drain hose is not kinked or otherwise blocked. Turn off the power. Find which Whirlpool washer parts in your machine need replacing and.

Remove a drain hose clog. Press this button twice to drain the washer. Once you have taken the above steps.

Once the Drain and Spin cycle completes the door should unlock. A hardworking washing machine may stop draining mid-cycle for a number of reasons such as a kink in the drain hose a clog of lint or fibers there or a rogue article of clothing stuck in the. The following steps outline how to disconnect the drain hoses and drain pump on the Whirlpool Cabrio washer.

Press Power and turn the cycle knob to Drain Spin Push Start The washing machine automatically unlocks when the water has drained. Press this button twice to drain the washer. Find the PauseCancel button on the control panel.

Finally open and close the washing machine door six times to send the reset signal to the system components. To reset your washing machine unplug it from the power outlet. Check the back of your machine for a water pump filter.