Whirlpool Washing Machine Off Balance

If OFb off balance load appears in display the load is out of balance.

Whirlpool washing machine off balance. The washer was useless as it would go out of balance on every load. An off-balance washing machine can be frighteningly noisy. I suspected something with the suspension rods but after removing the top of the machine and visually inspecting them from above the dont look broken or out of place.

The arms that operated these switches were bad to get bent. So with this code the system signals that the tank of the washing machine is overfilled with water. Once this is off the balance ring will be visible and you can see if it has liquid when moved.

Switch screwed onto the back frame of the washer visible from the outside of the washer with the panel removed. Whirlpool Washing Machine. At best a thumping and jumping machine is a nuisance but at worst an unbalanced machine can.

All four legs should be in. You should add the mixture of bicarbonate soda to the detergent container and pour the vinegar in the washing machine. If your washing machine is reaching its spin cycle and that is manifesting in it making loud banging noise then it is likely that the machine is out of balance in some way.

The front legs can be screwed either in or out to. Then remove the top tub ring which is held in place by plastic clips on the outer tub. Use the bubble level to confirm the washer is now level side-to-side and front-to-back with all four feet firmly in contact with the floor.

The machine needs to be physically close to level or they will get out of balance more often as the spinning tub will be spinning at an angle to the internals and will have less free play in one direction leading to the problem you have observed. Tub when empty leans toward the front of the machine when full beats up against one side. Hold down Temp.