Water In Conditioner Tray Washing Machine

30 November 2008 at 151AM.

Water in conditioner tray washing machine. I have an article about the problem of the fabric conditioner compartment left full of water which is normally caused by a blocked siphon tube but yours is an interesting fault regarding water coming back into the dispenser and setting off the siphoning. Allow the detergent drawer to soak in a wash basin and remove. To connect the washing machine to water supply make sure to use the.

My old machine also did this but I thought that waz just because it was old. Its possible your washing machine leans forward slightly and so the draw doesnt drain properly - try raising the two front feet screws a little. A way to test it is when youve got it all cleaned fill the conditioner compartment right up to the top with water this should then syphon away naturally.

The small fabric softener compartment in the soap dispenser drawer has a plastic cap or tube at the back. If larger amounts of water detergent or fabric softener remain remove the dispenser and clean thoroughly. The venturi works by.

If not soak the dispenser for another 20 minutes. Having said that it wont do it any harm your supposed to clean out the draw occasionally just like the filter. To check the screens turn the water off with the water valves.

A small amount of water within the dispenser area after a cycle is normal. Some Water is Normal. 3 Check the inlet hose screens and ensure no blockages.

At the end of the programme. Washing machines these days are available in several designs and perform several washing functions like bleaching pre-wash main washing fabric softening steam wash etc. Some machines have specific slots for fabric softners.