Washing Machine Rinse Cycle Not Filling Up

Drain the wash water 4.

Washing machine rinse cycle not filling up. It only does this during the rinse cycle as the first time it fills with cold water there is a ton and it only takes about 5-7mins to fill up on the first cycle but when it goes to fill up the 2nd time it takes more then 20-30mins to fill. My whirlpool top load washing machine only work on spinrinse cycle but not on any wash cycles. The rinse cycle begins immediately after the wash cycle has drained and spinned.

Read the full answer. Water comes into your washing machine for the wash and rinse cycles through the water inlet valve. Constantly fills with water which runs down the drain.

You will need to check power with a multimeter at your motor to see if you are getting power to any of the wires. So an excess of water at the wash or rinse cycle could be a result of a malfunctioning water inlet valve. So an excess of water at the wash or rinse cycle could be a result of a malfunctioning water inlet valve.

When sufficient air pressure is reached the pressure switch will switch on telling the washing machine to stop filling and start. If the water inlet valve is defective the wash may fill slowly or not fill at all. So when it gets to the rinse cycle and stops filling check the voltage at the water valve solenoid.

The water inlet valve requires sufficient water pressure to function properly. How to Fix a Washing Machine That Wont Fill With Water Step 1 - Examine Hoses. Start by pulling out the washer so you can see the hoses.

These fixes also apply if the rinse cycle isnt working at all the rinse cycle isnt filling with water or the water is filling extra slow during the cycle. If your Maytag Washer keeps filling or wont fill up with water you should check your water for improper installation or kinks in your water supply lines inlet valves and drain hose. If the switch has broken or is blocked then.