If youre lucky the issue might simply be that the filter needs cleaning be careful with your water valve filter though because many of them are very fragile.
Washing machine fills with water but does nothing else. If the motor is running the transmission is probably bad but it is usually controlled by voltage from the controller too and the machine is not economically repairable. Once the cycle completes youll notice theres no odor in your machine. I replaced it and the water flowed very fast filling enough water for the wash cycle in about a minute.
I dont hear any humming clicking or anything. I have a 10 year old top load Kenmore washing machine 11026844691 full of water. I shut the lid and walked away while it was filling.
After a while the display shows END as though it has completed its cycle. The issue was the water inlet valve where the water flows into the washer. Its a Kenmore 80 series washer model 11025842400.
The second problem is my sisters washing machine. I put everything back. To check out the water could be siphoning down the drain and washing machine fills with water then does nothing machine out and a.
It is better to be safe and let a qualified service engineer carry out the repair. The washer will spin without the water lines connected but it will not agitate unit the water level you have set is reached. It worked fine this morning.
Sometimes socks and other small articles of clothing can get into the drain system and clog the pump hose or the pump itself. It does not make any weird noises its quiet after it fills with water. Eventually I have to cancel the program wait for it to drain and then remove the wet clothes.