Roper Washing Machine Drum Loose Banging

The weights are attached to the drum and they help to control any excessive movement while the drum is spinning.

Roper washing machine drum loose banging. If it is damaged or defective replace it. Make sure the tub nut is not loose. You can be sure of rapid service.

If your washing machine drum is loose there is unfortunately nothing you can do yourself. Bolt could be left or right thread but most likely a normal thread. Sometimes small objects or articles of clothing can get caught in the drain pump.

The only reason a washing machine starts to shake excessively or make unusual noises due to irregular movements is that its washing machine drum is imbalanced. If the washer is making a loud noise the drive pulley might be worn out cracked loose or bent. If there is no locking tab then it must be held tightly in place by loctite although most manufacturers use some form of locking tab.

The drive pulley is connected by a belt to the motor and over time this can become loose or the motor can lose power. The shock absorbers dampen the vibration of the washer tub. To determine if anything is blocking the drain pump remove the.

Remove the drive pulley and inspect it carefully. Remove the fabric softener dispenser from the top of the agitator reach down inside and remove the cap use a 716 socket with extension to remove the agitator bolt. When unit goes into fast spin it begins to crash into sides of machine and gets out of control to the point of pulling the plug or pressing cancel.

Both of these problems can cause a noisy spin cycle with a lot of banging but thankfully in the majority of cases a professional technician should be able to fix it for you. One or more of the shock absorbers might be broken or worn out. It can get bent out of shape wear out or end up rubbing against the drum.