Maytag Washing Machine Stops At Rinse Cycle

Get shopping advice from experts friends and the community.

Maytag washing machine stops at rinse cycle. The timer on your washing machine controls all aspects of the wash spin and rinse cycles. Then the machine would not start at all and lid would not lock. Failing that one of these three options below will stop the cycle for most washing machine models.

CYCLE SIGNAL Touch to turn the end of cycle signal onoff and adjust the tone volume when a button is touched. The machine would not fill the tub with rinse water. You have 30 seconds to start lifting and lowering the lid.

The lid switch assembly prevents the washer from spinning when the lid is open. Then that stopped working altogether. This article will look at some of the problems your Maytag washer may face like when it keeps spinning wont go into spin cycles wont stop spinning wont spin fast wont complete a spin and how you can mitigate them.

Press Options button until LED next to Extra Rinse is illuminated to add a deep rinse after your main rinse has completed. AFTER RESET sequence A through E must be completed within 6 seconds. EXTRA RINSE Touch to automatically add a second rinse available on most cycles.

Some of the most common faults that will make your washer stop mid cycle include thermostat failure problems filling up with water for the rinse cycle or even pump problems that prevent your washer from draining. Select a wash setting and pull out the knob to start the cycle. To determine if the lid switch assembly is defective use a multimeter to test the lid switch for continuity.

If your top load washing machine or some older front load washers is stuck on one continuous cycle and will not advance and forward to the next wash cycle then most likely the washer timer is faulty and needs replacement. Only the cold water is used during the rinse cycle and it adds more water than the normal wash cycle so if it doesnt fill up to the correct level in 5 minutes the washer shuts off. Manually moving the knob to any rinse cycle or extra rinse cycle had no effect.