How To Remove Pump From Whirlpool Washing Machine

Lift up on the front of the pump.

How to remove pump from whirlpool washing machine. If you are sure that you figured it out prepare two types of screwdrivers. Turn off the water supply to the machineunplug from the mains supplyLay machine flat on its faceon an old pillow or similar to stop any damage to the front of the machineUnscrew and remove the tin backing plateAt the bottom of the drum on the right hand side is the pump unitThere is a rubber waste pipe from the drum to the pump held at either end with a sprung wire clipCompress the clip with a set of water pump. Remove the screws with a 14-inch nut driver.

On average expect to spend 300 to 400 for a pump. With the pump free you can easily access the impeller area and retrieve anything that may be caught. How to Reset GE Washing Machine.

Pull off the pump to inspect the two ports on the component. Remove the mounting bolts that hold the pump to the Cabrios interior using the nut driver. Know When to Call a Professional.

The pump can not be cleaned directly it sits behind a filter. The pump is situated at the bottom of the washing machine and is used to pump the water from the wash into the drain hose to be drained away. Although the Whirlpool Duet washer is a dependable appliance parts wear out or need adjustments.

Locate the drain hose and water supply hoses. Once you see the drain pump right in the middle of the machine use a. How much does it cost to replace a washing machine drain pump.

See If You Can Drain the Drain Hose. Find the screws securing the lower access panel to the washer cabinet. First unplug the lid switch from the wire harness near the control panel and then pry off the clips holding the body to the back wall of the washer.