How To Connect Water Inlet To Washing Machine

Open the washing machines drum to bring it out together with the other accessories including the washing machine installation manual.

How to connect water inlet to washing machine. To attach the water hose to the washing machine simply tighten the connector to the water inlet valve by hand in a clockwise direction. Remove bottom piece of the tap. The plastic connector is screwed onto the thread of the compression fitting.

I bought a McAlpine appliance trap with a single spigot to fit the dishwasher waste pipe to and a brass Y adaptor to fit both dishwasher and washing machine inlet hoses to the t bar connector didnt fit. Ø 2027 mm - 34 - 15 m. 1 Remove the adaptor from the water supply hose.

Thank you to everyone that replied. I have only ever washed on the cold water setting. Before you start check your washing machine or dishwasher is compatible with these fittings.

Step 1 Turn off the water supply and unplug the washer. Connect the hose from the cold water supply valve to the hot water inlet solenoid valve basically swap hose connections. Tighten the female end or coupler connection of the hot water hose onto the water hookup for the washing machine.

Turn on the cold water supply valve. Once these are firmly attached turn the red and blue levers on the valve 90 degrees so that it points along the pipe rather. Wrap plumbing tape around the threading of the tap.

The cold water inlet hose that you need to install is usually placed inside the drum of the machine. Step 3 Install the Y fitting. The Wpro cold water inlet hose extension allows you to extend the inlet hose of your appliance in order to reach the tap water supply.