Hotpoint Washing Machine Not Filling With Water

The water inlet valve requires at least 20 psi to function properly.

Hotpoint washing machine not filling with water. Went away for the weekend and came back to wash clothes and to my surprise there was a ton of water in it. Water Inlet Valve is Burned Out. Then remove the left hand side panel.

If you have a. Step 2 - Check Water Level Switch. If the tub stops filling when you unplug the washer it is an electrical problem.

If youre lucky the issue might simply be that the filter needs cleaning be careful with your water valve filter though because many of them are very fragile. If the water inlet valve is clogged with sediments the dishwasher wont fill properly. Have a bucket or bowl and towel ready as there may be a spurt of water.

Of course I freaked out and searched for the number to a service man and was going to call them. One end of these are the threaded connectors your hotcold water hoses screw too. OK The timer sends the voltage to the fill valve.

If your machine does not fill at the start or stops in mid cycle with no water in the drum or it wont rinse then there is normally a problem with the water intake system. It could be with either clean or dirty water. Its either a bad water valve or bad timer and you replaced the timer.

Andy Our Hotpoint WMUD 9427 washing machine recently gave a F05 fault code after cleaning out the pump filter pump and flushing through all the hoses Im now seeing a problem when I try to start any new cycle. You can check this by seeing if the machine will spin even with no water. Hold the hose over a bowl or bucket and switch the tap back on to see if there is a decent supply of water coming.