Hoover Washing Machine Filter Stuck

Remove the 2 or 4 transportation screws A on the back and remove the 2 or 4 flat washers rubber bungs and plastic spacer tubes B as illustrated in figure 1.

Hoover washing machine filter stuck. How to find your fault on your washing machine. SoTiredoftheWheelsontheBus Thu 01-Mar-12 044308. The white flat front part comes out but the black filter part wont turn at all.

If the washing machine is built-in unscrew the 3 or 4 transportation screws A and remove the 3 or 4 flat washers rubber bungs and. You might need somone to hold for you. For best results wash the filter in warm water and allow to dry thoroughly before putting it all back together.

Once the drum comes to rest at the end of the cycle the door will remain locked for up to 5 minutes before releasing the catch to enable the door to be opened. Whilst holding the button in rotate the knob 2 positions clockwise. 54 rows These may be retrieved by.

What this guide is intended to do is compliment all the other information that you will find in the site. A good washing machine filter should have retractable pipe at the side so that you can drain the water into a bowl. If you have a washing machine that is not pumping out the water and stuck full of water dont start here.

The pump may also be defective. Removing the kickplate by gently pulling it from the bottom in an. Always disconnect your appliance from the mains before you start examining it.

Check out or DIY repair video. Clip at the rear of the machine. Hoover recommend that you replace the filters once per year and new ones can be purchased from the spares section on this website.