F06 On Washing Machine

It was flashing back to back E02 and F06.

F06 on washing machine. Damage repair without professional assistance. Important Steps Wire Connection. Clean and replace the drain filter.

To diagnose the Drive Motor Tachometer Error yourself you need to access the motor by following these steps. Unplug washer or disconnect the power supply. Check if theres a pin coin or button in the drain and remove it.

This means the control is unable to properly detect motor speed and the machine will shut down. Hello andy and alli have an indesit IWE91480uk washing machine 9kg loadat the start of this week i found it displaying F06 with all lights flashingno time to do owt so left it til the weekenddoor locked red displaY on lcdto cut things short checked pump filter used manual tab to open doo. Push the pause button twice to get rid of the f06 error message.

The two sources of drainage the washing machine and the slop sink join at a Y and then after a trap go into the main waste-water stack. So I did all the simple checks described for the 06 checked the connectors checked the trap and there was no change. On the front side of the machine open the hatch in front of the drain filter and unscrew the filter.

Wire connection breakage is one of the common problems that cause your washer to show the e01 f01 error. To make things easier for you well walk you through the process and all the steps you need to do to fix the problem and get your washing machine up and running again. You can access the motor control module from the front or the back of your washer.

Prepare a towel or a bucket. Inspect the washing machines drainage and pump for any debris that could be clogging the waterways. You may need to replace a damaged burnt-out door interlock on a WMXTF-742 Hotpoint washing machine if you have a F06 fault code.