Cabrio Washing Machine F1 Code

Follow the hose and make sure its not pinched or kinked anywhere then check it.

Cabrio washing machine f1 code. A technician will normally check the air hose between the bottom of the washer tub and the pressure transducer on the machine control board. Error Code F1 or E2. Follow the indications below to troubleshoot this.

Once the codes are cleared put the washer into a manual diagnostic test and run the HEAVY AGITATION. To recap the cause of the Whirlpool Cabrio dryer F1 error code is a miscommunication between the control board and the rest of the machine. F1 Motor Triac Short.

First unplug the washing machine for about 5 minutes and plug it back in. When the Whirlpool Cabrio displays an F1 error this means the the control board is having difficulty communicating with the motor. This error code will display when the washer has tried six times to unlock the door but cannot.

The listed repair techiques have been performed on a Whirlpool Cabrio washer but it seems that the same instructions can be applied to other Whirlpool modes as well as Maytag Bravo and Kenmore Oasis washers. The Cabrio Washer F1 error code happens when the main control board gets a bad signal from the water level pressure switch circuit. This is normally caused by a pinched or ripped water level pressure switch hose.

Whirlpool Cabrio Washer Error F1. Since the door remained locked your likely problem was with the drain pump or excessive suds preventing the washer from draining out the water properly. It seems that Whirpool has issued a recall of certain Cabrio washers.

Cabrio Washer by Whirlpool F1 Error Code. However there are ways out of it. You wont start a cycle or complete the current one.