Bosch Washing Machine Water Level Sensor

We recommend you test them in pairs by locating and disconnecting them.

Bosch washing machine water level sensor. The tubing should be securely connected to the bottom of the outer tub and to the bottom of the water level switch. This error code signify a water supply error. The water level switch has three connectors.

Precisely dosed detergent not only protects your laundry but saves energy and water too. Inspect the air tube for kinks breaks or damage. This error code may be caused if your laundry is too much in the washer or the water level is too low.

Pressure switches and pressure sensors are used to detect the volume of water in a washing machine and when they go faulty you will often experience either over-filling not filling or errant error codes being displayed on the washing machine. Wash 47 spin 73 dB A Programs. Pull the machine out to expose the back.

The EcoSilence Drive motor in the washing machine sets a new benchmark in energy efficiency while also being one of the quietest motors in its class. With this one I had to use the Auto Sensing and it fills completely up and there was no way to stop it. Located at the top back of my machine and most front load machines are two brackets.

If your washing machines warranty has expired you can do it yourself. Check that the solenoid does not get stuck open and continuously fill with water. I didnt unhook anything as I intended to test the results before reassembling it.

Get Your bosch sensor Today. F 04 There is no signal from the gearmotor. Start TP11 sensor test programme.