Bosch Washing Machine Filter Won T Unscrew

If the machine is not pumping out the water properly you should release the residual water and remove obstructions in the filter.

Bosch washing machine filter won t unscrew. Then lean machine on to its side or back You will now need. Discussion in Appliances started by Jamjar 27 May 2007. Carefully check to see if there are any foreign objects in the pump.

Unscrew the water supply and lay a towel under it. Lay a towel on the floor and place a large tray or shallow container on top for the residual water to be drained. Is it supposed to turn slightly then pull out in which case Ill try pulling it Or does it just unscrew out after a few turns.

Pull the cap off the drain hose. Stick a couple screwdrivers or needle nose pliers into where the little tabs go and use that to turn it. But there are times when the filter does not want to be removed in any way it seems that it is tightly attached and can only be removed with a heavy tool.

This washing machine pump filter has two pumps attached to it one is for empty the other is for recycling the water into the drum. Tab type pump. No the filter needs a few turns before it can be removed.

I could unscrew it and pull out slightly anticlockwise to drain the water but couldnt actually pull out the whole plug bit. If it wont come out Id disconnect the machine from the mains and maybe the plumbing if the hoses arent long enough and lay it over onto its front where Id try to access the pump from underneath. Push the sealing cap back in.

Bosch Logixx 8 Express 1400 Yes I mean the filter at the bottom of the machine. Release the drainage hose from the clip. Remove clips on hoses to take pump off.