Bosch Washing Machine Fabric Softener Not Draining

I also find water in the softener dispenser cup little cup that pops out for washing - has two sides one for softener and the other for bleach after every load.

Bosch washing machine fabric softener not draining. The mixture of water and softener could be caused by stray water from the rinses leaking into the compartment. If you overload your washer with laundry the fabric softener could get trapped between. A bit more information is available here - Fabric Softener not draining away.

When the machine is new the most likely cause is that the washing machine is very slightly tipped forward. Clean the interior the thread and the housing of the pump so that the impeller is able to rotate. Apart from the above which explains what fabric softener may not be removed the single most common issue is with people complaining that water is not removed from the conditioner compartment.

Remove the hot and cold water hoses from the back of the washing machine. Fabric conditioner If the washing machine is going through the wash program properly but the fabric softener isnt being taken out its possible the water valve which flushes it away into the machine has failed. Adjust them until the washing machine sits level.

Normally there is a large water valve for the cold water and one section of it flushes water into the fabric softener compartment. Over time if not maintained your drawer may suffer from a build-up blocking the syphon tube this is a small tube located underneath the fabric softener cover - possibly resulting in a smelly washing machine. If the fabric conditioner tray of your Bosch Classixx washing machine is not emptying the flush nozzles may well be blocked.

I am currently soaking the dispenser tray in water with some bleach. Fabric Softener Compartment Full Of Water. Washing machine not draining fabric softener.

LEVEL THE MACHINE using a leveller front to back most important and also left to right by adjusting the feet by screwing them up or down. When a wash is complete the compartment is not empty as expected. Pull out the mains plug.