Beko Washing Machine Control Panel Not Working

The Machine door wont open and when turning off the machine the door will open but the machine is full of water as its on a new washing cycle.

Beko washing machine control panel not working. Press and hold down the start button and the programme button for three seconds. The machine is not spinning. Press and hold down the start button and the programme button for three seconds.

The machine will wash the clothes fine but at the end of the washing cycle the machine doesnt show that the cycle has ended but automatically returns to the program set for washing. Your Beko washing machine does not start. It is a simple process to reset the dishwashers control board and unlock the control panel.

If there is a short there its going to show up as a resistance reading of less than a couple of ohms. If the holding of the start pause button isnt resetting the machine then you will find the control board is faulty and will need to be replaced. When a front-load washers control panel wont light up or respond when you push the buttons it could mean the user interface board has failed.

All of the lights on the control panel should flash. If youre experiencing problems with your Beko dishwasher you can run a test cycle which can help you diagnose and troubleshoot the fault. I have come across this faulty quite a few times.

Please find out our contact details by clicking here. Genuine BEKO Main PCB Module Card For Washer Dryer WDJ7523023W WDC7523002W. I tried holding the reset button to end the cycle and it flashes END then goes back to the wash cycle for two seconds then back to end.

Posted January 20 2019. Opened it up as I own a multimeter although no expert. If the power switch has failed - follow our steps below to diagnose your washing machine and hopefully bring it back to life.