Amana Washing Machine Belt Change

Release the spring pressure on the idler pulley and unclip the motor plug on the side of the motor near the.

Amana washing machine belt change. As the drum spins the belt will align itself on the pulley and become tight. You need to take the bolts out of the motor brackets 4 and it would help if you drained all of the water out of the water pump so you can take the hoses off. Put the belt on the lip of the drum pulley and rotate while pulling back the tensioneridler pulley until the belt is seated on the groove of.

You will need to take the hoses off pump then there will be four 12 inch I think bolts holding the whole motor and pump take those out and remove wiring harness from motor roll old belt off tub pulley. Get shopping advice from experts friends and the community. How to Troubleshoot an Amana Washing Machine.

Remove the top cover of the Amana washing machine. Worn or broken drive belt can cause spin or washplate problems. You will see three.

Place the belt onto the motor pulley and pull back the tensioneridler pulley to allow slack of belt to be placed on washer drum pulley. Keep spinning the drum until you make 1 full revolution to ensure the belt. How do I reset my washing machine.

Put new belt on the tub and slid it back in. Remove the connectors from the terminal by grasping the connectors and pulling them off. Then remove the whole pump and motor and flip it over so pump is on top.

I have an AMANA Washer and it needs a new belt installed. Insert a putty knife between the top and front of the washer and press in to release the locking tab. Ok take the front cover off machine and you will see pump and motor asm.