Aeg Washing Machine Error Codes Efo

Find the answer to this and other Appliance questions on JustAnswer.

Aeg washing machine error codes efo. If the door seal is faulty it must be replaced by a service engineer. Check that the tap is not. The cycle is paused with door locked Start.

Verify it by opening the door and examining the door seal. Open the flap at the front of the washing machine on the bottom right. Displays due to washer over-sudsing or due to washer not filling with.

Causes for washer over-sudsing. Too much detergent was added. Drain hose kinkedcloggedimproperly positioned.

Question - I have an EFO Error code on my AEG Washing machine - L0. The error may be caused by the machines door seal leaking. Switch off the appliance and allow it to stand for a few hours until the foam subsides and then try the appliance again.

Otherwise the washing machine must pump up the water too far. Normally for the EF0 error code this is down to water leak in the base tray of the washer which has activated the flood switch. EF0 is a water leak in the base error code.

The seal should not be damaged cracked or have holes. A combined analysis of the results of the self-diagnosis system and the behavior of the washing machine will give a complete. Usually this can be a closed tap or a kinked water inlet hose.